Betekenis van:
vertical surface

Voorbeeldzinnen

1. the impacting surface shall be vertical and perpendicular to the median longitudinal plane of the vehicle struck;
2. ‘Corner of bumper’ means the vehicle's point of contact with a vertical plane which makes an angle of 60° with the vertical longitudinal plane of the vehicle and is tangential to the outer surface of the bumper (see Figure 2);
3. The service door entry height shall be measured as the vertical distance measured on a vertical plane of the horizontal projections of the mid point of the door aperture and the top surface of the lowest step.
4. This test specifies a method of test for measuring the lateral spread of flame along the surface of a specimen of product orientated in vertical position.
5. Gillnets are strings of single, double or triple netting walls, vertical, near the surface, in midwater or on the bottom, in which fish will gill, entangle or enmesh.
6. On the rear surface, the direction of impact from the rear towards the front in a longitudinal plane shall be at an angle of 45° to the vertical.
7. To determine the lower, upper and lateral limits of the illuminating surface, only screens with horizontal or vertical edges shall be used.
8. The vertical plane through the wheel axis intersects its median plane along a straight line which meets the supporting surface at one point.
9. It should include consideration of the body size of the animal, a surface sufficiently cushioned to prevent injury, adequate stall drainage, correctly positioned stall dividers and head rails, lateral and vertical freedom for head movement and adequate lunging space.
10. To determine the lower, upper and lateral limits of the illuminating surface only screens with horizontal or vertical edges shall be used to verify the distance to the extreme edges of the vehicle and the height above the ground.
11. To cover all possible positions of the ball, in the field given by the horizontal distance from the mounting surface and the vertical range of f (fmin to fmax), two devices are to be tested:
12. The vehicle is moved in order to increase by three degrees the angle formed by the median longitudinal plane and the supporting surface (by moving the vehicle towards the vertical).
13. ‘Corner of frontal protection system leading edge’ means the frontal protection system’s point of contact with a vertical plane which makes an angle of 45° with the vertical longitudinal plane of the vehicle and is tangential to the outer surface of the frontal protection system.
14. ‘Corner of frontal protection system’ means the frontal protection system's point of contact with a vertical plane, which makes an angle of 60° with the vertical longitudinal plane of the vehicle and is tangential to the outer surface of the frontal protection system (see Figure 3);
15. Except in the case of test 2 for interior mirrors (see paragraph 6.1.3.2.2.6.1), when the pendulum is in a vertical position the horizontal and longitudinal vertical planes passing through the centre of the hammer shall pass through the centre of the reflecting surface as defined in paragraph 2.1.1.10. The longitudinal direction of oscillation of the pendulum shall be parallel to the longitudinal median plane of the vehicle.